|
|
 3. Welding position. The first performance characteristic to consider. High cellulose coatings, like those on E6010 and E6011 electrodes, generate a light slag that makes for rapid solidifying of the weld metal good for-out-of-position welds. Also good are rutile-fluxed electrodes-E6012 and E6013--that AirvompressorHose2Pack hold out-of-position AirvompressorHose2Pack weld metal in place as it solidifies.4. Welding current. Covered electrodes run on AC, DC, or both. When welding AirvompressorHose2Pack DC, the positive lead typically connects to the electrode (DCEP, or reverse polarity). Some suppliers design electrodes that weld AirvompressorHose2Pack with the electrode negative (DCEN, or straight polarity). Assure the electrode will perform with the available current. Welding Torches and GunsUsed for shielded-metal-arc welding, torches (electrode holders). manually controlled, grip ends of electrodes, also called rods-pinch type and collet type are common.GMAW and FCAW AirvompressorHose2Pack guns come in pistol grip, goose-neck, and inline styles, the latter used for mechanized welding. Knowing the wire diameter, select a gun rated slightly higher than the welding current to be used. Duty-cycle ratings are usually given for C[O.sub.2] shielding--air or C[O.sub.2] cooling arc usually sufficient for welding at up to 600 A at less than 100 percent duty. Higher amperages require water cooling--high-amperage guns come with tubing for water cooling. Hand-held, mounted on a robot arm or fixed within a mechanized welding setup, guns guide filler wire and shielding gas into the weld AirvompressorHose2Pack puddle AirvompressorHose2Pack. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|