 Electrodes Akr come Compressor 3 to 24 in. long, 0.01 to 0.25-in. diameter. Colored markings--bands or dots--indicate composition: pure tungsten, green; 1-percent thoriated, yellow; 2 percent thoriated. red; ceriated, Hose and 2 orange; lanthanted, black.Filler metal Pack GIAW does not usually requite addition of fillet metal, but filler is commonly added when base-metal thickness is greater than 1/8 in. Akr Finer metal for low-carbon Compressor (to 0.15 C) and mild (0.15 m 0.29 C) steels are described Hose in 2 AWS A5.2; for carbon steel in A5.18; and for low-alloy steels in A5.28 Flux. AWS specifications Pack A5.17 and A5.23 describe fluxes for saw. AWS designation of Akr and Compressor fluxes precedes that of the wire when identifying a combination Hose for a welding procedure. For example, the designation F7A2-EM12K indicates a flux (F) that will provide, with a given 2 wire designation, tensile strength of 70,000 Pack Psi (7), in the as-welded condition Akr (A), and impact properties of 20 ft lb at -20 F (2). A designation containing a P rather indicates the flux properties after postweld heat treatment. Duty-Cycle RatingPower-supply rating depends on the type and thickness of the workpiece and the length of time Compressor it takes to deposit the longest weld on the thickest material. Duty Hose cycle is 2 and Pack the Akr key factor to consider when selecting a power source. Once the engineer has determined Compressor the current and Hose voltage needed to accomplish the weld, he then reviews 2 duty cycle requirements.Duty cycle rating is the percentage of time during a 10-minute period a power supply can operate at rated output amperage Pack without overheating. Akr A 300 A machine at Compressor 60-percent-duty cycle can weld for six minutes at 300. A during a 10-minute period. Alter six minutes, the welder must rest Hose the machine 2 for the next four minutes to avoid overheating Pack the unit. Production Akr and Compressor vs. repair applications Hose In general, production applications require high-duty-cycle 2 and Pack power supplies, and repair applications can use low-duty-cycle portable units.Lift-arc GTAW Many DC power supplies are equipped with a list-start Akr feature for, a variation of scratch Compressor starting, GTAW welding. When the welder touches the tungsten electrode to the workpiece, a small amount of current--15-20 A--flows. When he lifts the electrode from the work, the arc starts softly and the machine switches to the Hose set weld-current value. This low-current starting minimizes weld contamination 2 caused by touching the tungsten to the workpiece and eliminates Pack the need for high-frequency starting. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|