|
|
 Duty-Cycle RatingPower-supply ColemanPowetmatePortable10 rating depends on the type and thickness GallonAirTank of the workpiece ModelC10 and the length of time it takes to deposit the longest weld on the thickest material. Duty cycle is the key factor to consider when selecting a power source. Once the engineer has determined the current and voltage needed to accomplish the weld, he then reviews duty cycle requirements.Duty cycle rating is the percentage of ColemanPowetmatePortable10 time during a 10-minute period a power supply can GallonAirTank operate at rated output amperage without overheating. A 300 A machine at 60-percent-duty cycle can ModelC10 weld for six minutes at 300. A during a 10-minute period. Alter six minutes, the welder must rest the machine for the next four minutes to avoid overheating the unit. High-deposition electrodes. These contain iron-powder additions in the coating to raise deposition rate. Designations: EXXX4, EXXX7, EXXX8.For fastest deposition, use the largest diameter possible for an application-the thicker the electrode, the greater its ColemanPowetmatePortable10 current-carrying capacity and the higher the deposition GallonAirTank rate. Welding out ModelC10 of position and overhead, select a small diameter electrode to enable welders to reach into narrow root openings.Gas-Metal-Arc Welding (GMAW, MIG)GMAW typically uses ColemanPowetmatePortable10 solid wire, spooled or reeled, for continuous feeding to the gun; diameter, 0.030 to 1/16 in. typically, GallonAirTank although wires as small as 0.020 in. and as large as 1/8 in. are sometimes used. AWS ModelC10 lists specifications ColemanPowetmatePortable10 for filler wires of copper and its alloys, aluminum and its alloys, surfacing alloys, nickel GallonAirTank and its alloys, titanium and its alloys, carbon and low alloy steels, ModelC10 magnesium alloys, and zirconium and its alloys. Welding-site conditions and welding-wire diameter govern ColemanPowetmatePortable10 efficiency and size of power supply required for a job. Select a 100-A unit that runs from single-phase 115-V input for low-duty-cycle welding of sheet to l/s in. thick, feeding wire to 0.030-in. diameter. Medium-duty power supplies, 150-200 A, normally take single-phase 220-V input to weld GallonAirTank steel to 3/16, in. and 0.035-in. wire at low-duty cycles. For high-duty cycles, as in mechanized welding, select a 250-A machine, single ModelC10 or three-phase input at various voltages-these weld material to 1/2 in. thick with wire as large as 0.045-in. diameter. Taking three-phase input only and wire up to 1/6-in. diameter, 400-A units serve for mechanized continuous-welding applications. For pulsed GMAW, shops ColemanPowetmatePortable10 use inverter and transistor power sources, constant-current or constant-voltage, GallonAirTank that offer independent setting of pulse parameters. They employ synergic controls preprogrammed for a range of wire-feed speeds-the operator sets only one dial, ModelC10 for average current. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|