|
|
 For flux-cored-arc welding, shops use CV or CC types, 300 to 1,500 A, 25 to 50 V, rated 60- to 100-percent-duty cycle. CV types are more popular aiecompressorkit because wire-feed speed, set before welding, controls welding current. Cc types require a variable-speed or voltage-sensing wire feeder.Gas-tungsten-arc welding (GTAW) requires a constant-current (AC or DC) power supply with a steep volt-amp curve to minimize current change for variation in voltage or arc length. They come rated to 1,500 A, 10 to 75 V, at 40- to 100-percent-duty cycle. Most GTAW power supplies come equipped with high-frequency circuitry for arc initiation and stabilization, gas valves, and cooling-water valves for high-current welding. High-frequency arc start is useful when the aiecompressorkit maximum open-circuit voltage allowed by NEMA standards, 80 to 100 V, will not establish and maintain a stable arc. GTAW torches come air-cooled and water-cooled. Their aiecompressorkit heads align in-line with the body or at 90, 120, or 135 degrees to it. Nozzles, specified by inside diameters, run 1/4 to aiecompressorkit 5/8 in. Vendors offer special designs: longer to give improved accessibility to the weld aiecompressorkit joint, or wider to extend shielding gas coverage.Saw guns come in three-types-side, concentric, and deep-groove flux delivery.In oxyfuel welding (ofw), heat comes from burning gases, rather than arcs, Torches hold separate tubes for fuel gas and oxygen, blended in a mixer assembly. A torch assembly comprises a handle (aluminum, stainless steel, or brass); a mixing chamber; and a brass welding tip or cutting head. Light-duty torches weld sheer metal to 3/16, in. thick; medium, to 1/2 in.; aiecompressorkit heavy, 1/2 in. and up. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|