|
|
 Saw Uses CV or CC Power Supplies,... 200 to 1,500 A, 28 to 44 V, at 60- to 100-percent-duty aifcompressertank cycle. Automatic units commonly use up to 1,500 A on one wire. Cv welding machines that offer variable-slope control give the welder extra adjustability, and can extend the usefulness of the machine to weld a range of material thicknesses and types.Selection of Power SourcesWhen choosing a power source, start by checking NEMA specs. NEMA Class I aifcompressertank arc-welding power sources deliver rated output at 60-, 80-, or 100-percent-duty cycle: Class II units, 30-, 40-, or 50-percent; and Class III, 20 percent. First consider capacity and kind of current needed for the job. Rely on the manufacturer''s rating as being conservative: don''t buy more capacity than needed. Choose low--duty-cycle machines only for maintenance or for intermittent aifcompressertank welding. If portability is important, consider inverter units. Duty-Cycle RatingPower-supply rating depends on the type and thickness of the workpiece and the length of time it takes to deposit the longest weld on the thickest material. Duty cycle is the key factor to consider when selecting a power source. Once the engineer has determined the current and voltage needed to accomplish the weld, he then reviews duty cycle requirements.Duty cycle rating is the percentage of time during a 10-minute period a aifcompressertank power supply can operate at rated output aifcompressertank amperage without overheating. aifcompressertank A 300 A machine at 60-percent-duty cycle can weld for six minutes at 300. A during a 10-minute period. Alter six minutes, the welder must rest the machine aifcompressertank for the next four minutes to avoid overheating the unit. * Reduces the size of the etched zone for improved cosmetics.Less EN time improves cleaning action to remove heavier oxidation, lessens penetration, and widens the bead profile.Inverter-based machines also let operators adjust welding-output frequency from 20 to 250 Hz. Decreasing frequency products a broader arc cone, which widens the weld-bead profile and better-removes impurities from the surface of the workpiece. It also transfers the maximum amount of energy to the workpiece, ideal for work requiring heavy metal deposition.Increasing frequency produces a tight, focused arc cone. This narrows the weld bead, helpful when welding in corners and on root passes and fillet welds. Independent amperage control of the EN and EP portions of the AC cycle allows the operator to fine-tune the amount of energy directed into the workpiece, as well as take heat off of the tungsten electrode. A basic, professional-quality AC GTAW power supply lets the operator adjust for variables: amperage, balance control, and shielding-gas pre-flow and post-flow time. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|