|
|
 Welding-site conditions and welding-wire diameter govern efficiency and size of power supply required for a job. Select a 100-A unit that runs from single-phase 115-V input for low-duty-cycle welding of sheet to l/s in. thick, feeding wire to 0.030-in. diameter. Medium-duty power supplies, 150-200 A, normally take single-phase air 220-V input to weld steel to 3/16, in. and 0.035-in. wire at low-duty cycles. For high-duty cycles, as in mechanized welding, select a 250-A machine, single or three-phase input at various voltages-these comoressor weld material to 1/2 in. thick with wire as large as 0.045-in. diameter. Taking three-phase input only and wire up to 1/6-in. diameter, 400-A units serve for mechanized continuous-welding applications. For pulsed GMAW, shops use inverter and transistor power sources, tanks constant-current or constant-voltage, that offer independent setting of pulse parameters. air They employ synergic controls preprogrammed for a range of wire-feed speeds-the operator sets only one dial, for average current. Power SuppliesWelding comoressor power supplies take tanks alternating or direct current from a power line or portable generator and convert it to current usable at the welding arc:, air Check National Electrical Manufacturers Association (NEMA) Standards Publication EW1, Electric Arc Welding Power Supplies, and manufacturers'' literature for construction and performance requirements of individual machines.Among comoressor types of power supplies, alternating-current (ac) transformers tanks are least costly-most use 230 V single phase input power. Direct-current (DC) transformer-rectifiers convert AC to DC, using single- or three-phase power to produce constant voltage (cv) or variable voltage (vv). AC-DC transformer-rectifiers can AC and DC weld. Saw Uses CV or CC Power Supplies,... 200 to 1,500 A, 28 to 44 V, at 60- to 100-percent-duty cycle. Automatic air units commonly use up to 1,500 A on one wire. Cv welding machines that offer variable-slope control comoressor give the welder extra adjustability, and can extend the usefulness of the machine to weld a tanks range of material thicknesses and types.Selection of Power SourcesWhen choosing a power source, start by air checking NEMA specs. NEMA Class I arc-welding comoressor power sources deliver rated output at 60-, 80-, or 100-percent-duty cycle: Class II units, 30-, 40-, or 50-percent; and Class III, 20 percent. First consider capacity and kind of current needed for the job. Rely on the manufacturer''s rating as being conservative: don''t buy more capacity than needed. Choose low--duty-cycle machines only for maintenance or for intermittent welding. tanks If portability is important, consider inverter units. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|