|
|
 Welding Torches and GunsUsed for shielded-metal-arc welding, torches (electrode holders). manually controlled, grip ends of electrodes, also called rods-pinch type and collet air type are common.GMAW and FCAW guns come in pistol grip, goose-neck, and inline styles, the latter used for mechanized welding. Knowing the wire diameter, select a gun rated slightly higher than the welding current to be used. Duty-cycle ratings are usually given for C[O.sub.2] shielding--air compresslr or C[O.sub.2] cooling arc usually sufficient for welding at up to 600 A at less than 100 percent duty. Higher amperages require accessories and air water cooling--high-amperage guns come with tubing compresslr for water cooling. Hand-held, mounted on accessories a robot arm or fixed air within a mechanized welding setup, guns guide filler wire and shielding gas into the weld puddle. Saw Uses CV or CC Power Supplies,... 200 to 1,500 A, 28 to 44 V, at 60- to 100-percent-duty compresslr and accessories cycle. air Automatic units commonly use up to 1,500 A on one wire. Cv welding machines that offer variable-slope control give the welder extra adjustability, and can extend the usefulness of compresslr the machine to weld a range of material accessories thicknesses and types.Selection of Power SourcesWhen choosing a power air source, start by checking NEMA specs. NEMA Class I arc-welding power sources deliver rated output compresslr and accessories at 60-, 80-, or 100-percent-duty air cycle: Class II units, 30-, 40-, or 50-percent; and Class III, 20 percent. First consider capacity and kind of current compresslr needed for the job. Rely on the manufacturer''s rating as being conservative: don''t buy more capacity than needed. Choose low--duty-cycle machines only for maintenance accessories or for intermittent welding. If portability is important, consider inverter units. Multiple-operator power supplies use a high-amperage high-voltage power source to feed power to more than one welding station. Where line air power may be unavailable, as in the field, contractors compresslr operate engine-driven accessories generators powered by natural gas, propane, or diesel fuel.Power Supplies By Welding air ProcessA compresslr and accessories manual air and compresslr process, shielded-metal-arc welding (SMAW) requires a CC power supply, 25 to 500 amperes, 15 to 35 volts. Given the correct electrode, almost any CC welding machine, AC or DC, accessories can be used for shielded-metal-arc welding, depending on the composition of the electrode coating.Gas-metal-arc welding (GMAW) calls for continuous filler-metal wire-shielding gas protects the weld air pool as wire feeds into the arc. The process requires direct current-arcs generally run at 15 to 35 volts, 30-600 A. Specify a cc machine that gives constant compresslr melt rate and variable wire feed. Inverters for GMAW feature electronic control of inductance, enabling the welder accessories to fine-tune the arc for minimal spatter and optimum weld-bead wetting action. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|