|
|
 GTAW torches come air-cooled and water-cooled. Their heads align in-line with the air body or at 90, 120, or 135 degrees to it. Nozzles, specified by inside diameters, run 1/4 conpressor to 5/8 in. Vendors offer special designs: longer to give improved accessibility to the weld joint, kits or wider to extend shielding gas coverage.Saw guns come air in three-types-side, conpressor concentric, and deep-groove flux delivery.In oxyfuel welding (ofw), heat comes kits from burning gases, rather than arcs, air Torches hold separate tubes for fuel gas and oxygen, blended in a mixer assembly. A torch assembly comprises a handle (aluminum, stainless steel, or brass); conpressor a mixing chamber; and a brass welding tip or cutting head. Light-duty torches weld sheer metal to 3/16, in. thick; kits medium, to 1/2 in.; heavy, 1/2 in. and up. For flux-cored-arc air welding, shops use CV or CC types, 300 to 1,500 A, 25 to 50 V, rated 60- to 100-percent-duty cycle. CV types are more popular because wire-feed speed, set before welding, controls welding current. Cc types require a variable-speed or voltage-sensing wire feeder.Gas-tungsten-arc conpressor and kits welding (GTAW) requires air a constant-current (AC or DC) conpressor power supply with a steep volt-amp curve to minimize current change for variation in voltage or arc length. They come rated to 1,500 A, 10 to 75 V, kits at 40- to 100-percent-duty cycle. Most GTAW air power supplies conpressor come equipped with high-frequency circuitry for arc initiation and stabilization, gas valves, and cooling-water valves for high-current welding. High-frequency arc start is useful kits and air when the maximum open-circuit voltage conpressor allowed by NEMA standards, kits 80 to 100 V, will not establish and air maintain a stable conpressor arc. Production vs. repair applications In general, production applications kits require high-duty-cycle power supplies, and repair air applications can use low-duty-cycle portable conpressor units.Lift-arc GTAW Many DC power supplies are equipped with a list-start feature for, a variation of scratch kits starting, GTAW welding. When the welder touches the tungsten electrode to the workpiece, a small amount of current--15-20 A--flows. When he lifts the electrode from the work, the arc starts softly air and the machine switches to conpressor the set weld-current kits value. This low-current starting minimizes weld contamination caused by touching the tungsten to the workpiece and eliminates the need for high-frequency starting. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|