|
|
 Remote control of current and voltage is a plus if the welding operator is located away from the power source.Robotic and automatic applications generally require high-duty-cycle power supplies, and controls and connections for interfacing to the robot aircomoressorreceivertanks or automatic feature.Supervisory control of the process will prevent the welder from changing the welding procedures. Here, select a power supply or controller that enables the supervisor to program the procedures, then lock them into the control memory, Some power supplies or controllers offer the welder limited control of the process.Input power to power supplies can bc single and/or three phase, with voltage from 115 to 575 V and input frequencies of 50, 60, or 50/60 Hz. Note that many inverter power supplies are designed to operate on both single- and three-phase input, and have automatic input-voltage selection and linking. GTAW torches come air-cooled and water-cooled. Their heads align in-line with the body or at 90, 120, or 135 degrees to it. Nozzles, specified by inside diameters, run 1/4 to 5/8 in. Vendors offer special designs: longer aircomoressorreceivertanks to give improved accessibility to aircomoressorreceivertanks the weld joint, or wider to extend shielding gas coverage.Saw guns come in three-types-side, concentric, and deep-groove flux delivery.In oxyfuel welding (ofw), heat comes from burning gases, rather than arcs, Torches hold separate tubes for fuel gas and oxygen, blended in a mixer assembly. A torch assembly comprises a handle (aluminum, stainless steel, or brass); a mixing chamber; and a brass welding tip or cutting head. Light-duty torches weld sheer metal to 3/16, in. thick; medium, to 1/2 in.; heavy, 1/2 in. and up. Duty-Cycle RatingPower-supply rating depends on the type and thickness of the workpiece and the length of time it takes to deposit the longest weld on the thickest material. Duty cycle is the key factor to consider when selecting a power source. Once the engineer has determined the current and voltage needed to accomplish the weld, he then reviews duty cycle requirements.Duty cycle rating is the percentage of time during a 10-minute period a power supply can operate aircomoressorreceivertanks at rated output amperage without overheating. A 300 A machine at 60-percent-duty aircomoressorreceivertanks cycle can weld for six minutes at 300. A during a 10-minute period. Alter six minutes, the welder must rest the machine for the next four minutes to avoid overheating the unit. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|