|
|
 For flux-cored-arc welding, shops use CV or CC types, 300 to 1,500 A, 25 to 50 V, rated 60- to 100-percent-duty cycle. CV types are more popular because wire-feed speed, set before welding, controls welding current. Cc types require a variable-speed or voltage-sensing wire feeder.Gas-tungsten-arc welding (GTAW) requires a constant-current (AC or DC) power supply with a steep volt-amp curve to minimize aircomoressortank current change for variation in voltage or arc aircomoressortank length. They come rated to 1,500 A, 10 to 75 V, at 40- to 100-percent-duty cycle. Most GTAW power supplies come equipped with high-frequency aircomoressortank circuitry for arc initiation and stabilization, gas valves, and cooling-water valves for high-current welding. High-frequency arc start is useful aircomoressortank when the maximum open-circuit voltage allowed by NEMA standards, 80 to 100 V, will not establish and maintain a stable arc. 1. Mechanical properties of the base material. Tensile strength and yield strength of the weld metal should equal or exceed that of the base material. Ductility and toughness at low temperatures may also be important. High-temperature service requires resistance to creep. Shock loading requires impact resistance. In general, weld metal should match base-material properties.2. Composition of the base material.For stainless steels, low alloy steels, nickel and copper alloys, and materials that serve in corrosive atmospheres, chemical composition is important. Consider the possibility of electrochemical aircomoressortank corrosion between base and weld metal of different compositions. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|