|
|
 Duty-Cycle RatingPower-supply rating depends on the type and thickness of the workpiece and the length of time it takes to deposit the longest weld on the thickest material. aircompeessertank Duty aircompeessertank cycle is the key factor to consider when selecting a power source. Once the engineer has determined the current and voltage needed to accomplish the weld, he then reviews duty cycle requirements.Duty cycle rating is the percentage of time during a 10-minute period a power supply can operate at rated aircompeessertank output amperage without overheating. A 300 A machine at 60-percent-duty cycle can weld for six minutes at 300. A during a 10-minute period. Alter six minutes, the welder must rest the machine for the next four minutes to avoid overheating the unit. 3. Welding position. The first performance characteristic to consider. High cellulose coatings, like those on E6010 and E6011 electrodes, generate a light slag that makes for rapid solidifying of the weld metal good for-out-of-position welds. Also good are rutile-fluxed electrodes-E6012 and E6013--that hold out-of-position weld metal in place as it solidifies.4. Welding current. Covered electrodes aircompeessertank run on AC, DC, or both. When welding DC, the positive lead typically connects to the electrode (DCEP, or reverse polarity). Some suppliers design electrodes that weld with the electrode negative (DCEN, or straight polarity). Assure the electrode will perform with the available current. Filler-metal selection for FCAW depends on base-metal composition, cleanliness of base metal, thickness, a0d service. AWS specifications: A5.20, Specification for Carbon Steel Electrodes for Flux-cored Arc Welding, for low-carbon steel up to 0.15 C and mild steel 0.15 to 0.29 C; A5.29, Specification for Low Alley Electrodes for Flux-cored Arc Welding, for steel of higher carbon content and the low-alloy types; A5.22, Specification for Flux-cored Corrosion-Resisting Chromium and Chromium-Nickel Steel Electrodes, for stainless steels.Gas-Tungsten-Arc Welding (GTAW, TIG)GTAW rises an arc between a nonconsumable aircompeessertank electrode and the work. It joins with or without filler metal. AWS A5.12 lists electrode types and sizes. All are tungsten, aircompeessertank some with thoria, zirconia, ceria, or lanthana added. Thoria provides higher current-carrying capacity than prime tungsten with less contamination of the weld pool. Other benefits: better arc start, greater arc stability. Zirconiated electrodes perform well with alternating current: the arc is stable, the electrode retains a (tailed end during welding, and has current-carrying capacity of thoriated electrodes. Zirconiated electrodes resist contamination and minimize tungsten contamination of weld metal. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|