|
|
 For flux-cored-arc welding, shops use CV or CC types, 300 to 1,500 A, 25 to 50 V, rated 60- to 100-percent-duty cycle. CV types are more popular because wire-feed speed, set before welding, controls welding current. Cc types aircompressoetanks require a variable-speed or voltage-sensing wire feeder.Gas-tungsten-arc welding (GTAW) requires a constant-current (AC or DC) power supply with a steep volt-amp curve to aircompressoetanks minimize current change for variation in voltage or arc length. They come rated to 1,500 A, 10 to 75 V, at 40- to 100-percent-duty aircompressoetanks cycle. Most GTAW power supplies come equipped with high-frequency circuitry for arc initiation and stabilization, gas valves, and cooling-water valves for high-current welding. High-frequency arc start is useful when the maximum open-circuit voltage allowed by NEMA standards, 80 to 100 V, will not establish and maintain a stable arc. Welding Torches and GunsUsed for shielded-metal-arc welding, torches (electrode holders). manually controlled, grip ends of electrodes, also called rods-pinch type and collet type are common.GMAW and FCAW guns come in pistol grip, goose-neck, and inline styles, aircompressoetanks the latter used for mechanized welding. Knowing the wire diameter, select a gun rated slightly higher than the welding current to be used. Duty-cycle ratings aircompressoetanks are usually given for C[O.sub.2] shielding--air or C[O.sub.2] cooling arc usually sufficient for welding at up to 600 A at less than 100 percent duty. Higher amperages require water cooling--high-amperage guns come with tubing for water cooling. Hand-held, mounted on a robot arm or fixed within a mechanized welding setup, guns guide filler wire and shielding gas into the weld puddle. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|