|
|
 For flux-cored-arc welding, shops use CV or CC types, 300 to 1,500 A, 25 to 50 V, rated 60- to 100-percent-duty cycle. CV types are more popular aircompressoracvessories because wire-feed speed, set before welding, controls welding current. Cc types require a variable-speed or voltage-sensing wire feeder.Gas-tungsten-arc welding (GTAW) requires a constant-current (AC or DC) power supply with a steep volt-amp curve to minimize current change for variation in voltage or arc length. They come rated to 1,500 A, 10 to 75 V, at 40- to 100-percent-duty cycle. Most GTAW power supplies come equipped with high-frequency circuitry for arc initiation and stabilization, gas valves, and cooling-water valves for high-current welding. High-frequency arc start is useful when the maximum open-circuit voltage allowed by NEMA standards, 80 to 100 V, will not establish and maintain a stable arc. Welding-site conditions and welding-wire diameter govern efficiency and size of power supply required for a job. Select a 100-A unit that runs from single-phase 115-V input for low-duty-cycle welding of sheet to l/s in. thick, feeding wire to 0.030-in. diameter. Medium-duty power supplies, 150-200 A, normally take single-phase 220-V input to weld steel to 3/16, in. and 0.035-in. wire at low-duty cycles. For high-duty cycles, as in mechanized welding, select a 250-A machine, single or three-phase input at various voltages-these weld material to 1/2 in. thick with wire as large as 0.045-in. diameter. Taking three-phase input only and wire up to 1/6-in. diameter, 400-A units serve aircompressoracvessories for mechanized continuous-welding aircompressoracvessories applications. For pulsed GMAW, shops use inverter and transistor power aircompressoracvessories sources, constant-current or constant-voltage, that offer independent setting of pulse parameters. They employ synergic controls preprogrammed for a range of wire-feed speeds-the operator sets only aircompressoracvessories one dial, for average current. Saw Uses CV or CC Power Supplies,... 200 to 1,500 A, 28 to 44 V, at 60- to 100-percent-duty cycle. Automatic units commonly use up to 1,500 A on aircompressoracvessories one wire. Cv welding machines that offer variable-slope control give the welder extra adjustability, and can extend the usefulness of the machine to weld a range of material thicknesses and types.Selection of Power SourcesWhen choosing a power source, start by checking NEMA specs. NEMA Class I arc-welding power sources deliver rated output at 60-, aircompressoracvessories 80-, or 100-percent-duty cycle: Class II units, 30-, 40-, or 50-percent; and Class III, 20 percent. First consider capacity and kind of current needed for the job. Rely on the manufacturer''s rating as being conservative: don''t buy more capacity than needed. Choose low--duty-cycle machines only for maintenance or for intermittent welding. If portability is important, consider inverter units. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|