|
|
 Production vs. repair applications In general, production applications require high-duty-cycle power supplies, and repair applications can use low-duty-cycle portable units.Lift-arc GTAW Many DC power supplies are equipped with a list-start feature for, a variation of scratch starting, GTAW welding. When the welder touches the tungsten electrode to the workpiece, a small amount of current--15-20 A--flows. When he lifts the electrode from the work, the arc starts softly and the machine switches to the set weld-current value. This low-current starting minimizes weld contamination caused by touching the tungsten to the workpiece aircompressorit and eliminates the need for high-frequency starting. Remote control of current and voltage is a plus if the welding operator is located away from the power source.Robotic and automatic applications generally require high-duty-cycle power supplies, and controls and connections for interfacing to the robot or automatic feature.Supervisory control of the process will prevent the welder from changing the welding procedures. Here, select a power supply or controller that enables the supervisor to program the procedures, then lock them into the control memory, aircompressorit Some power supplies or controllers offer the welder limited control of the process.Input aircompressorit power to power supplies can bc single and/or three phase, with voltage from 115 to 575 V and input frequencies of 50, 60, or 50/60 Hz. Note that many inverter power supplies are designed to operate on both single- and three-phase input, and have automatic input-voltage selection and linking. Welding Torches and GunsUsed aircompressorit for shielded-metal-arc welding, torches (electrode holders). manually controlled, grip ends of electrodes, also called rods-pinch type and collet type are common.GMAW and FCAW guns come in pistol grip, goose-neck, and inline styles, aircompressorit the latter aircompressorit used for mechanized welding. Knowing the wire diameter, aircompressorit select a gun rated slightly higher than the welding current to be used. Duty-cycle ratings are usually given for C[O.sub.2] shielding--air or C[O.sub.2] cooling arc usually aircompressorit sufficient for welding at up to 600 A at less than 100 percent duty. Higher amperages require water cooling--high-amperage guns aircompressorit come with tubing for water cooling. Hand-held, mounted on a robot arm or fixed within a mechanized welding setup, guns guide filler wire and shielding gas into the weld puddle. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|