|
|
 Production vs. repair applications In general, production applications require high-duty-cycle power supplies, and repair applications can use low-duty-cycle portable units.Lift-arc GTAW Many DC power supplies are equipped with aircompressorreplacemengpressureswitches a list-start feature for, a variation of scratch starting, GTAW welding. When the welder touches the tungsten electrode to the workpiece, a small amount of current--15-20 A--flows. When he lifts the electrode aircompressorreplacemengpressureswitches from the work, the arc starts softly and the machine switches to the set weld-current value. This low-current starting minimizes weld contamination caused by touching the tungsten to the workpiece and eliminates the need for high-frequency starting. Duty-Cycle RatingPower-supply rating depends on the type and thickness of the workpiece and the length of time it takes to deposit the longest weld on the thickest material. Duty cycle is the key factor to consider when selecting a power source. Once aircompressorreplacemengpressureswitches the engineer has determined the current and voltage needed to accomplish the weld, he then reviews duty cycle requirements.Duty cycle rating is the percentage of time during a 10-minute period a power supply can operate at rated output amperage without overheating. A 300 A machine at 60-percent-duty cycle can weld for six aircompressorreplacemengpressureswitches minutes at 300. A during a 10-minute period. Alter six minutes, the welder must rest the machine for the next four minutes to avoid overheating the unit. Saw Uses CV or CC Power Supplies,... 200 to 1,500 A, 28 to 44 V, at 60- to 100-percent-duty cycle. Automatic units commonly use up to 1,500 A on one wire. Cv welding machines that offer variable-slope control give the welder extra adjustability, and can extend the usefulness of the machine to weld aircompressorreplacemengpressureswitches a range of material thicknesses and types.Selection of Power SourcesWhen choosing a power source, start aircompressorreplacemengpressureswitches by checking NEMA specs. NEMA Class I arc-welding power sources deliver rated output at 60-, 80-, or 100-percent-duty cycle: Class II units, 30-, 40-, or 50-percent; and Class III, 20 percent. First consider capacity and kind of current needed for the job. Rely on the manufacturer''s rating as being conservative: don''t buy more capacity than needed. Choose low--duty-cycle machines only for maintenance or for intermittent welding. If portability is important, consider inverter units. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|