 Shielded-Metal-Arc Welding (SMAW, STICK)AWS (American Welding Society) A5 specifications Set standards for electronics for SMAW of carbon, stainless, and low alloy steels; aluminum copper, and nickel and their alloys and weld-surfacing. Designations for covered electrodes carry the prefix ''E''. aircompressortznks Packaged to AWS specifications, electrodes come in boxes, cans, or other containers, labeled with their aircompressortznks AWS specification and trade name, quality control (heat or lot) number, supplier name, diameter and length, and weight of contents. Specifications require that every electrode bc marked for identification near with its aircompressortznks numeric designation the grip end.To select a covered SMAW electrode, consider these factors, in approximate order of importance. Welding Torches and GunsUsed for shielded-metal-arc welding, torches (electrode holders). manually controlled, grip ends of electrodes, also called rods-pinch type and collet type are common.GMAW and FCAW guns come in pistol grip, goose-neck, and inline styles, the latter used for mechanized welding. Knowing the wire diameter, select a gun rated slightly higher than the welding current to be used. Duty-cycle ratings are usually given for C[O.sub.2] shielding--air or C[O.sub.2] cooling arc usually sufficient for welding at up to 600 A at less than 100 percent duty. Higher aircompressortznks amperages require water cooling--high-amperage guns come with tubing for water cooling. Hand-held, mounted on a robot arm or fixed within a mechanized welding setup, guns guide filler wire and shielding aircompressortznks gas into the weld puddle. High-deposition electrodes. These contain iron-powder additions in the coating to raise deposition rate. Designations: EXXX4, EXXX7, EXXX8.For fastest deposition, use the largest diameter possible for an application-the thicker the electrode, the greater its current-carrying capacity and the higher the deposition rate. Welding out of position and overhead, select a small diameter electrode to enable welders to reach into narrow root openings.Gas-Metal-Arc Welding (GMAW, aircompressortznks MIG)GMAW typically uses solid wire, spooled or reeled, for continuous feeding to the gun; diameter, 0.030 to 1/16 in. typically, although wires as small as 0.020 in. and as large as 1/8 in. are sometimes used. AWS lists specifications for filler wires of copper and its alloys, aluminum and its alloys, surfacing alloys, aircompressortznks nickel and its alloys, titanium and its alloys, carbon and low alloy aircompressortznks steels, magnesium alloys, and zirconium and its alloys. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|