|
|
 Saw Uses CV or CC Power Supplies,... aircomprrssortanks 200 to 1,500 A, 28 to 44 V, at 60- to 100-percent-duty cycle. Automatic units commonly use up to 1,500 A on one wire. Cv welding machines that offer variable-slope control give the welder extra adjustability, and can extend the usefulness of the machine to weld a range of material thicknesses and types.Selection of Power SourcesWhen choosing a power source, start by checking NEMA specs. NEMA Class I arc-welding power sources deliver rated output at 60-, 80-, or 100-percent-duty cycle: Class II units, 30-, 40-, or 50-percent; and Class III, 20 percent. First consider capacity and kind of current needed for the job. Rely on the manufacturer''s rating as being conservative: don''t buy more capacity than needed. Choose low--duty-cycle machines only for maintenance or for intermittent welding. If portability is important, consider inverter units. Multiple-operator power supplies use a high-amperage high-voltage power source to feed power to more than one welding station. Where line power may be unavailable, as in the field, contractors operate engine-driven generators powered by natural gas, propane, or diesel fuel.Power Supplies By Welding ProcessA manual process, shielded-metal-arc welding (SMAW) requires a CC power supply, 25 to 500 amperes, 15 to 35 volts. Given the correct electrode, almost any CC welding machine, AC or DC, can aircomprrssortanks and aircomprrssortanks be used for shielded-metal-arc welding, depending on the composition of the electrode coating.Gas-metal-arc welding (GMAW) calls for continuous filler-metal wire-shielding gas protects the weld pool as wire feeds into the arc. The process requires direct current-arcs generally run at 15 to 35 volts, 30-600 A. Specify a cc machine that gives constant melt rate and variable wire feed. Inverters for GMAW feature electronic control of inductance, enabling the welder to fine-tune the arc for minimal spatter and optimum weld-bead wetting action. Remote control of current and voltage is a plus if the welding operator is located away from the power source.Robotic and automatic applications aircomprrssortanks generally aircomprrssortanks require high-duty-cycle power supplies, and controls and connections for interfacing to the robot or automatic feature.Supervisory control of the process will prevent the welder from changing the welding procedures. Here, select a power supply or controller that enables the supervisor to program the procedures, then lock them into the control memory, Some power supplies or controllers offer the welder limited control of the process.Input power to power supplies can bc single and/or three phase, with voltage from 115 to 575 V and input frequencies of 50, 60, or 50/60 Hz. Note that many inverter power supplies are designed to operate on both single- and three-phase input, and have automatic input-voltage selection and linking. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|