|
|
 Saw Uses CV or CC Power Supplies,... 200 to 1,500 A, 28 to 44 V, at 60- to 100-percent-duty airvompressortank cycle. Automatic units commonly use up to 1,500 A on one wire. Cv welding machines that offer variable-slope control give the welder extra adjustability, and can extend the usefulness of the machine to weld a range of material thicknesses and types.Selection of Power SourcesWhen choosing a power source, start by checking NEMA specs. NEMA Class I arc-welding power sources deliver rated output at 60-, 80-, or 100-percent-duty cycle: Class II units, 30-, airvompressortank 40-, or 50-percent; and Class III, 20 percent. First consider capacity and kind of current needed for airvompressortank the job. Rely on the manufacturer''s rating as being conservative: don''t buy more capacity than needed. Choose low--duty-cycle machines only for maintenance or for intermittent welding. If portability is important, consider inverter units. Multiple-operator power supplies use a high-amperage high-voltage power source to feed power to more than one welding station. Where line power may be unavailable, as in the field, contractors operate engine-driven generators powered by natural gas, propane, or diesel fuel.Power Supplies By Welding ProcessA manual process, shielded-metal-arc welding (SMAW) requires a CC power supply, 25 to 500 amperes, 15 to 35 volts. Given the correct electrode, almost any CC welding machine, AC or DC, can be used for shielded-metal-arc welding, depending on the composition of the electrode coating.Gas-metal-arc welding (GMAW) calls for continuous filler-metal wire-shielding gas protects the weld pool as wire feeds into the arc. The process requires direct current-arcs generally run at 15 airvompressortank to 35 volts, 30-600 A. Specify a cc machine that gives constant melt rate and variable airvompressortank wire feed. Inverters for GMAW feature electronic control of inductance, enabling the welder to fine-tune the arc for minimal spatter and optimum weld-bead wetting action. 3. Welding position. The first performance characteristic to consider. High cellulose coatings, like those on E6010 and E6011 electrodes, generate a light slag that makes for rapid solidifying of the weld metal good for-out-of-position welds. Also good are rutile-fluxed electrodes-E6012 and E6013--that airvompressortank hold out-of-position airvompressortank weld metal in place as it solidifies.4. Welding current. Covered electrodes run on AC, DC, or both. When welding DC, the positive lead typically connects to the electrode (DCEP, or reverse polarity). Some suppliers design electrodes that weld with the electrode negative (DCEN, or straight polarity). Assure the electrode will perform with the available current airvompressortank. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|