|
|
 For flux-cored-arc welding, shops use CV or CC types, 300 to 1,500 A, 25 to 50 V, rated 60- to 100-percent-duty cycle. CV types are more popular because wire-feed speed, set before welding, controls welding current. Cc types require a variable-speed or voltage-sensing wire feeder.Gas-tungsten-arc welding (GTAW) requires a constant-current (AC or DC) power supply with a steep volt-amp aluminumairtanks curve to minimize current change for variation in voltage or arc length. They come rated to 1,500 A, 10 to 75 V, at 40- to 100-percent-duty cycle. Most GTAW power supplies come equipped with high-frequency circuitry for arc initiation and stabilization, gas valves, and cooling-water valves for high-current welding. High-frequency arc start is useful when the maximum open-circuit voltage allowed by NEMA standards, 80 to 100 V, will not establish and maintain a stable arc. 3. Welding position. The first performance aluminumairtanks characteristic to consider. High cellulose coatings, aluminumairtanks like aluminumairtanks those on E6010 and E6011 electrodes, generate a light slag that makes for rapid solidifying of the weld metal good for-out-of-position welds. Also good are rutile-fluxed aluminumairtanks electrodes-E6012 and E6013--that hold out-of-position weld metal in place as it solidifies.4. Welding current. Covered electrodes run on AC, DC, or both. When welding DC, the positive lead typically connects to the electrode (DCEP, or reverse polarity). Some suppliers design electrodes that weld with the electrode negative (DCEN, or straight polarity). Assure the electrode will perform with the available current. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|