|
|
 3. Welding position. The first performance characteristic to consider. High cellulose coatings, like those on E6010 and E6011 electrodes, generate a light slag that makes for rapid solidifying aorcompressoraccessory of the weld metal good for-out-of-position welds. Also good are rutile-fluxed aorcompressoraccessory electrodes-E6012 and E6013--that hold out-of-position weld metal in place as it solidifies.4. Welding current. Covered electrodes run on AC, DC, or both. When welding DC, the positive lead typically connects to the electrode (DCEP, or reverse polarity). Some suppliers design electrodes that weld with the electrode negative (DCEN, or straight polarity). Assure the electrode will perform with the available current. For flux-cored-arc aorcompressoraccessory welding, shops use CV or CC types, 300 to 1,500 A, 25 to 50 V, rated 60- to 100-percent-duty cycle. CV types are more popular because wire-feed speed, set before welding, controls welding current. aorcompressoraccessory Cc types require a variable-speed or voltage-sensing wire feeder.Gas-tungsten-arc welding (GTAW) requires a constant-current (AC or DC) power supply with a steep volt-amp curve to minimize current change for variation in voltage or arc length. They aorcompressoraccessory come rated to 1,500 A, 10 to 75 V, at 40- to 100-percent-duty cycle. Most GTAW power supplies come equipped with high-frequency circuitry for arc initiation and stabilization, gas valves, and cooling-water valves for high-current aorcompressoraccessory welding. High-frequency arc start is useful when the maximum open-circuit voltage allowed by NEMA standards, 80 to 100 V, will not establish and maintain a stable arc. Mix recovered flux before reusing to maintain its manufactured properties. Three-parts new flux mixed with one-part recovered flux works well. Consult the flux manufacturer for proper proportions.Fluxes classify as basic, acid, or neutral. Fluxes that contain oxides and break up easily during welding are basic. These provide oxidizing action and alloy with the weld metal to obtain desired mechanical properties. Acidic oxides break up slightly, for the same reasons. Welding voltage must remain within the range specified by the manufacturer of acidic and basic fluxes. Excessive arc voltage reduces the alloying of flux constituents with the weld metal. Neutral fluxes do not oxidize alloying elements or add alloying elements to the weld. As amperages increase, flux particle size should decrease. Excessive current for a particle size produces unstable art''s and uneven weldbead edges. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|