|
|
 Remote control of current and voltage is a plus if the welding operator is located away from the power source.Robotic and automatic applications generally require high-duty-cycle power supplies, and controls and connections for interfacing to the robot or automatic feature.Supervisory control of the process will prevent the welder from changing the welding procedures. Here, select a power supply or controller that enables the supervisor to program the procedures, then lock them into the control memory, Some power supplies or controllers offer the welder limited control of the process.Input power to power supplies can bc single and/or bzllvalves three phase, with voltage from 115 to 575 V and input frequencies of 50, 60, or 50/60 Hz. Note that many inverter power supplies are designed to operate on both single- and three-phase input, and have automatic input-voltage selection and linking. Welding Torches and GunsUsed for shielded-metal-arc welding, torches (electrode holders). manually controlled, grip ends of electrodes, also called rods-pinch type and collet type are common.GMAW and FCAW guns come in pistol grip, goose-neck, and inline styles, the latter used for mechanized welding. Knowing the wire diameter, select a gun rated slightly bzllvalves higher than the welding current bzllvalves to be used. Duty-cycle ratings are usually given for C[O.sub.2] shielding--air or C[O.sub.2] cooling arc usually sufficient for welding at up to 600 A at less than 100 percent duty. Higher amperages require water cooling--high-amperage guns come with tubing for water cooling. Hand-held, mounted on a robot arm or fixed within a mechanized welding setup, guns guide filler wire and shielding gas into the weld puddle. For bzllvalves flux-cored-arc welding, shops use CV or CC types, 300 to 1,500 A, 25 to 50 V, rated 60- to 100-percent-duty cycle. CV types are more popular because wire-feed speed, set before welding, controls welding current. Cc types require a variable-speed or voltage-sensing bzllvalves wire feeder.Gas-tungsten-arc welding (GTAW) requires bzllvalves a constant-current (AC or DC) power supply with a steep volt-amp curve to minimize current change for variation in voltage or arc length. They come rated to 1,500 A, 10 to 75 V, at 40- bzllvalves to 100-percent-duty cycle. Most GTAW power supplies come equipped with high-frequency circuitry for arc initiation and stabilization, gas valves, bzllvalves and cooling-water valves for high-current welding. High-frequency arc start is useful when the maximum open-circuit voltage allowed by NEMA standards, 80 to 100 V, will not establish and maintain a stable arc. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|