|
|
 Multiple-operator power supplies use a high-amperage high-voltage comprwssor power source to feed power to more than one welding station. Where line power may be unavailable, as in the field, contractors operate engine-driven generators air powered by natural gas, propane, or diesel fuel.Power Supplies By Welding ProcessA manual tank process, shielded-metal-arc comprwssor welding (SMAW) air and tank and comprwssor requires a CC power supply, 25 to 500 amperes, 15 to 35 volts. Given the correct electrode, almost any CC welding machine, AC or DC, can be used for shielded-metal-arc welding, air depending tank on the composition of the electrode coating.Gas-metal-arc welding (GMAW) calls for continuous filler-metal comprwssor wire-shielding gas protects the weld pool as wire feeds into the arc. The process requires air direct current-arcs generally run tank at 15 to 35 volts, 30-600 A. Specify a cc machine that gives constant melt rate and variable comprwssor wire feed. Inverters for GMAW feature electronic control of inductance, air enabling tank the welder to fine-tune comprwssor the arc for minimal spatter and air optimum weld-bead tank wetting action. 3. Welding position. The first performance characteristic to consider. High cellulose coatings, like those on E6010 and E6011 electrodes, generate a light slag that makes for rapid solidifying of the weld metal good comprwssor for-out-of-position welds. Also good are rutile-fluxed electrodes-E6012 and E6013--that hold out-of-position weld metal in place as it solidifies.4. Welding current. Covered electrodes run on AC, DC, or both. When welding air DC, the positive lead typically connects to the electrode (DCEP, or reverse polarity). Some suppliers design electrodes that weld with the electrode negative (DCEN, or straight polarity). Assure the electrode will perform with the available current. Welding-site conditions and tank welding-wire diameter govern efficiency and size of power supply required for a job. Select a comprwssor and air 100-A unit that runs from single-phase 115-V input for low-duty-cycle welding of sheet to l/s in. thick, feeding wire to 0.030-in. diameter. Medium-duty tank power supplies, 150-200 A, normally take single-phase 220-V input to weld steel to 3/16, in. and 0.035-in. wire comprwssor and air at low-duty cycles. For high-duty cycles, as in mechanized welding, select a 250-A machine, single or three-phase input at various voltages-these weld material to 1/2 in. thick with wire as large as 0.045-in. diameter. Taking three-phase input only and wire up to 1/6-in. diameter, 400-A units serve for tank mechanized continuous-welding applications. For pulsed comprwssor GMAW, shops use inverter and transistor power sources, constant-current or constant-voltage, that offer independent setting of pulse parameters. They employ synergic air controls tank preprogrammed for a range of wire-feed speeds-the operator sets only one dial, for average current. Searching for accessories for your air compressor? We offer the best selection of cheap air compressor accessories on the internet. Check out our website for great deales on all of our air compressor accessories!
|